Officezone MightyLam 2700, Руководство по эксплуатации

Страница: 11 / 26

5. Turn the Motor Switch on to start the Laminating and Pull Rollers.
6. Feed a piece of thin cardboard about 10” x 25” against the film so that it is centered between
the two Heat Shoes. Push the cardboard and film into the Laminating Rollers. See figure 5.
Watch cardboard pass through the back (pull) rollers to avoid a wrap-aound.
7. When the feed card has completely exited the Pull Rollers at the rear of the laminator turn
the Motor Switch off.
8. Replace the feed table.
9. If you are ready to laminate, the Heat Switch should be in the on position and the Heat Indi
cator should have gone off.
Adjusting Mandrel/Film Tension...
Each type of laminating film has different characteristics and may require laminator adjust
ment. The tension should be set so that the film moves over the Heat Shoes without wrinkles
as the film enters the laminator. Best results are obtained if tension adjustments are made
while the unit is at operating temperature. If any adjustments are required use the following
procedure:
1. Switch the Heaters on. Wait for the Heat Shoes to reach operating temperature. The Heat
Indicator will go off when the proper temperature is reached. You can check the temperature
by reading the thermometer located on the right side of the laminator.
2. Press the Motor switch to on.
3. Locate the knob on the right side of the Top Supply Mandrel. See Figure 7 below. Turn the
knob to adjust the tension (clockwise to increase, counter clockwise to decrease) until the film
passes over the Top Heat Shoe without wrinkles and the web between the Laminating and Pull
Rollers is tight.
Note: This adjustment requires only a few degrees of turn. If the knob is
turned too far, you may stall the drive motor.
Figure 7
4. If necessary locate the knob on the right side of the bottom Supply Mandrel and adjust the
tension as in step 3 above.
5. If you are not ready to laminate, turn the Motor Switch and Heat Switch off.
7
1-800-543-5454 www.officezone.com
OfficeZone