Officezone MightyLam 2700, Руководство по эксплуатации

Страница: 10 / 26

Threading Laminating Film...
These instructions apply to poly-in film rolls (shiny side out, dull side in).
1. For the top supply roll place the mandrel ends into the slots in the top of the laminator. If
you are facing the front of the laminator the film should unwind toward you from the
bottom of the roll as in figure 3 below.
Figure 3
2. Pull 6”-12” of film from the top roll. Pass the film under the idler bar, heat shield and over
the heat shoes. Make sure the shiny side of the film is against the shoes. See figure 5&6 be
low.
3. For the bottom supply roll, remove the feed table. Place the mandrel ends into position in
the lower mandrel holder slots. If you are facing the front of the laminator the film should
unwind away from you from the bottom of the rollers as shown in figure 4 below.
Figure 4
4. Pull 6”-12” of film from the bottom roll. Pass it under the lower idler bar. You can “drop-
down” the lower idler bar to give you more clearance. After doing so, return the idler bar to its
upper position for running the machine. Drape the film from the bottom roll over the film from
the top roll. See figures 5&6 below.
NOTE: The shiny side of the film must always go against the
Heat Shoes.
CAUTION! The Heat Shoes reach a temperature of up to 350°F.
Do not touch the surface of the Heat Shoes.
Figure 5 Figure 6
6
1-800-543-5454 www.officezone.com
OfficeZone