TOYOTA
Reference
450Q
Procedure
Issue B 5/23/16
Page | 6
i.
Run the gray, white, amplifier connectors, sub
connectors and 10 mm ground terminal, towards
the passenger side kick panel. You want this
wire the same length as the black sub amplifier
connector.
(Fig. 3-11)
j.
Run the gray, white, amplifier connectors, sub
connectors and 10 mm ground terminal, towards
the passenger side kick panel. You want this
wire the same length as the black sub amplifier
connector
(Fig. 3-12)
k
. Plug your OEM Audio Plus quick-sync wiring
harness connectors into the back of your radio.
Plug in the remainder of your radio connectors
and reinstalled radio, bezel and trim.
(Fig. 3-13)
4.
Quick-Sync Wiring Harness Installation
a.
Remove the passenger side threshold by pulling
in an upward motion.
(Fig. 4-1)
Fig. 4-1
Fig. 3-11
Fig. 3-11
Fig. 3-13
