TOYOTA
Reference
400CF
Procedure
Issue A 8/14/14
Page | 8
g.
Remove the weather-stripping on the rear
passenger side door to access the side panel.
(Fig 4-6)
h.
Apply pressure to the panel pushing towards the
driver side to disengage the locking clips. The
bottom-locking clip of the panel may require a
panel tool to disengage. Position the tool
between the tab and the frame of the vehicle
and pry open, (the panel does not require full
removal.)
(Fig. 4-7)
h.
You'll need just enough room to run the
umbilical cable to the rear cargo tray opening.
With the rear cargo tray off you will be able to
clearly see the channel where to run the
umbilical wire.
(Fig. 4-8)
i.
Run the wires far as possible on the top side the
wheel-well. Then reach from the cargo tray
opening to pull the remainder of the cable out.
Connector should rest in the center of the
opening with about 3 inches of slack.
(Fig. 4-9)
j.
Reinstall your passenger rear side panel,
weather-stripping, kick panel and threshold.
Fig. 4-7
Panel Tool
Fig. 4-9
Fig. 4-8
Fig. 4-6
