Odorox IDU, Руководство пользователя, Страница: 10 / 21

8
Owner’s Manual
INSTALLATION INSTRUCTIONS
Return or Supply Air Plenum Installation
STEP 1: Turn off all power to HVAC equipment (lockout and tag).
STEP 2:
Use the included template to mark the necessary cutout and holes onto the duct.
STEP 3: Cut out the 7 inch by 12 inch opening (use safety glasses and leather gloves).
STEP 4: Drill the eight quarter inch holes (use safety glasses and leather gloves).
STEP 5: Install duct reinforcement plate (IDU02MD130) on outside of duct.
STEP 6:
Route duct reinforcement plate (IDU02MD140) through the opening and position over studs (use
caution to avoid dropping plate inside duct).
STEP 7: Secure duct reinforcement plates by installing four 8-32 nuts and lock washers (provided).
STEP 8:
Install the IDU™ unit by routing the aluminum chamber through the opening, and securing to the plate
with four 8-32 screws (provided).
STEP 9: Connect the line voltage as per code to the HVAC EAC terminals or to the blower control. A current
sensing relay or pressure switch may be necessary. Check with the equipment manufacturer.
STEP 10: Remove the power entry access cover on the IDU™ unit. Install connector for the power feed in the 7/8
inch hole. Connect cable/wire as per code and make connections to identified wires for ground, neutral,
and line (see electrical schematic).
STEP 12: Re-install the power entry access cover of the IDU™ unit.
STEP 13:
Turn power back on to the HVAC equipment (remove lockout and tag).
TM