oddWires IoT-Bus, Документация

Страница: 84 / 165

iot-bus Documentation, Release latest
These lines send a packet. The packet is transmitted on endPacket(). The complete example is shown below.
#include <SPI.h>
#include <LoRa.h>
#define DIO0 35
#define SS 5
#define RESET 17
int counter = 0 ;
void setup () {
LoRa.setPins(SS, RESET, DIO0);
Serial.begin( 115200 );
while ( ! Serial);
Serial.println( "LoRa Sender" );
if ( ! LoRa.begin( 915E6 )) {
Serial.println( "Starting LoRa failed!" );
while ( 1 );
}
}
void loop () {
Serial.print( "Sending packet: " );
Serial.println(counter);
// send packet
LoRa.beginPacket();
LoRa.print( "hello " );
LoRa.print(counter);
LoRa.endPacket();
counter ++ ;
delay( 5000 );
}
25.2 LoRa Receiver
#include <SPI.h>
#include <LoRa.h>
#define DIO0 35
#define SS 5
#define RESET 17
int counter = 0 ;
void setup () {
LoRa.setPins(SS, RESET, DIO0);
These lines include the libraries required and define the DIO0, SS and RESET pins required to use the IoT-BUs LoRa
board.
80 Chapter 25. IoT-Bus LoRa Example