EXPLORE
E7
2 0 1 9 I N S T A L L & O P E R A T I O N M A N U A L
7
Installation (Once hull preparation is complete)
1. Test
light(s)
before
fitting.
2. (If using Isolation Kit) Insert the Isolation Kit front washer into the drilled hole and apply marine sealant to seal
between the Front Washer and the hull.
3. Apply sealant to the rear of the mounting tube assembly’s bezel to ensure a complete unbroken seal around
the light.
Make sure sealant fills in the recess groove on the reverse of the light bezel:
4. Ensure the light angle is correct for the location before assembling the light. If available, follow OceanLED
Light Placement Chart position to indicate what light angle should be installed into each location around
the hull. The LED Indicator is used as a reference point for beam direction and should be at the top of the
rear face of the light body, as pictured, if installed correctly. If viewed from inside. From outside, the
OceanLED logo should be in the correct orientation, as below, indicating the direction of the beam. For
more details, consult Appendix 6.6.
5. Insert the complete light unit (mounting tube as light cartridge) into the hull, pressing the light hard into
the hull and twist slightly to spread the sealant behind the light to ensure good adhesion.
This process is made much easier if a second person is inside the hull to receive the light and install the
locking equipment whilst supporting the light from the outside. Breakages due to lights falling out of the hull
are NOT covered under warranty and can cause serious bodily injury as can any falling object.
