EXPLORE
E7
2 0 1 9 I N S T A L L & O P E R A T I O N M A N U A L
1
Preface
READ AND FOLLOW ALL INSTRUCTIONS IN THIS MANUAL
CAUTION
(Risk Group 2): Possibly hazardous optical radiation emitted from this product. Do not stare at operating
lamp. May be harmful to the eye.
WARNINGS
Before installing your OceanLED Light, read and follow all warning notices and instructions which are
included. Failure to follow safety warnings and instructions can result in property damage, severe injury or
even death.
Before installing your OceanLED Light, check local laws for restrictions regarding the use of coloured lights
in your area.
Do not operate lights out of water for a period longer than 5 minutes followed by an OFF period of at least 1
hour. Exceeding this may cause damage to the light unit.
Ensure the bonding point of the light is fitted to the cathodic protection system on the vessel. Check
conductivity between earth bonding point and aluminium bronze front bezel. If mounting the light to metal,
carbon fibre or wooden hull, ensure that suitable measures have been put in place to account for the effects
of galvanic corrosion or wood deterioration, i.e. use of Delrin sleeve components (Isolation Kit).
Salt is an inherently corrosive material. Metal parts and certain natural and man- made surfaces are
particularly susceptible to corrosion and deterioration when used in and around saltwater. Some OceanLED
lights contain combinations of plastic and polymer products which are impervious to saltwater corrosion,
however, screws and fasteners used for the installation must be of a marine grade type stainless steel or
equivalent and monitored annually to ensure the lights remain in service for years to come.
Never connect/disconnect lights with power applied as irreversible damage may occur.
Ensure lights are always fully submerged and not fitted on planing / running surfaces that may impact on
water since this may damage the product.
Never Use Solvents! Cleaners, fuel, and other products that may contain strong solvents, such as acetone,
attack many plastics greatly reducing their strength and irreversibly damaging the special lens coatings and
cable sheathings.
Remove the protectors from the connectors on the rear of the light ONLY if the connector will be used
immediately. If the connectors on the light(s) are not in use, leave protector(s) on.
DANGER
RISK OF ELECTRIC SHOCK OR ELECTROCUTION
This underwater light must be installed by a licensed or certified electrician in accordance with all applicable
local codes and ordinances. Improper installation will create an electrical hazard which could result in death
or serious injury to swimmers, installers, or others due to electrical shock, and may also cause damage to
property. Always disconnect the power to the light at the circuit breaker before servicing the light.
