48
Choosing an installation location
Cut out the work surface (refer to the dimensions shown in the illustration).
For installation and use, a gap of 50mm minimum must be placed around
the hole.
The worktop must be at least 5 cm thick. The worktop must be made of a
heat-resistant material, otherwise the thermal radiation of the table may
cause considerable deformation. See below:
SEAL = JOINT
L (mm) W (mm) H (mm) D(mm) A (mm) B (mm) X (mm)
590
520
52
48
560
490
50 mini
In any case, ensure that your cooktop is sufficiently well ventilated and that
the air inlet and outlet are not blocked. Make sure the table is in good
condition. See below.
Note: The safety distance between the induction hob and the
cupboards above is at least 760 mm.
VII. INSTALLATION