EN-1
8
VI.
CLEANING AND MAINTENANCE
ICING
The humidity brought by the products and by the ambient air leads over time to
the formation of frost and ice in the appliance. A thin layer of frost or ice has no
influence on the operation of the freezer, but the thicker the layer becomes, the
higher the energy consumption. A thin layer of ice can be removed with a freezer
ice scraper.
Never use an electrical device or pointed object that could damage the inside of
the device.
When the frost or ice layer reaches a thickness of 4 to 5 mm, the freezer must
be defrosted. Defrosting is recommended when the freezer is near or completely
empty.
Proceed as follows:
1.
Unplug the unit.
2.
Take out the frozen products. Keep them in a cool or well-wrapped
place to
minimize defrosting as much as possible.
3.
Leave the lid open.
4.
Place a container of hot (non-boiling) water in the freezer, close the lid
and
wait about 30 minutes, then remove the frost with a plastic scraper.
Never
use hair dryers, electric heaters or other similar electrical appliances for
defrosting.
5. Drain all defrost water either with a cloth or a water collection tray through
the defrost hole (see instructions below). Clean and dry it with a soft cloth.
6.
Wait about five minutes after turning the machine back on before
putting frozen products back in.
Содержание OCEACCF99W3
Страница 1: ...C Cong lateur coffre 99L Chest freezer 99L OCEACCF99W3...
Страница 52: ...OCEACCF99W3_IM_FR EN_102023...
