Oceanic GEO, Руководство по эксплуатации

Страница: 56 / 75

56
GEO AIR OPERATING MANUAL
© Oceanic, 2022 Doc. No. 12-5673-r05 (10/11/22)
RUN TIMER
The Gauge Mode allows for a Run Timer to be added to the Gauge Dive Main screen.
NOTE: Once the Run Timer is added and started, it can be removed and continue to run in the background until it is
again added. Though it can only be started and stopped while it is being displayed.
SELECT
ADV
.
LIGHT
MODE
ADD RUN TIMER
SELECT
ADV
.
LIGHT
MODE
display
run timer
RUN TIMER
remove
run timer
start/stop
timer, if on
main
reset timer,
if on
main and
stopped
0:00 - 199:59 (min:sec),
( - : - - ) if greater than
199:59
DELAYED VIOLATION 3 (DV3)
If you descend deeper than the maximum functional depth*, the audible alarm will sound and the alarm LED will flash. At the same time, the UP
message will flash and depth will only indicate dashes signifying that you are too deep. The Gas Time Remaining will also be represented by dashes.
* The maximum functional depth (330 ft / 100 m) is the depth at which the GEO AIR can properly perform calculations or provide accurate display
information.
Upon ascending above the maximum functional depth, current depth will be restored, however, max depth will continue to be displayed as dashes
on the alt 2 screen for the remainder of that dive. The Log for that dive will also display dashes for max depth.
flashing