Ocean Insight NIRQuest Series, Инструкция по установке и эксплуатации

Страница: 12 / 28

MNL-1002 Rev A
4
Installation
You must install the spectroscopy application prior to connecting the NIRQuest Spectrometer to the PC. The spectroscopy
application installs the drivers required for spectrometer installation. If you do not install the software first, the system will not
properly recognize the NIRQuest Spectrometer.
If you have already connected the NIRQuest Spectrometer to the PC prior to installing the software, consult
Troubleshooting for
information on correcting a corrupt NIRQuest Spectrometer installation.
USB Mode
To connect the NIRQuest Spectrometer to a PC via the USB port, the PC must be running the Windows operating system.
1. Install the spectroscopy application on the destination computer, and then reboot the system.
2. Plug the +5VDC wall adapter into an electrical outlet, then connect the power cord to the 2.5 mm power jack (older versions
may have a 1.3 mm power jack) on the rear of the NIRQuest Spectrometer.
3. Locate the USB cable that came with the NIRQuest Spectrometer.
4. Insert the square end of the cable into the rear of the NIRQuest Spectrometer, and then insert the rectangular end into the USB
port of the computer.
If the software was installed prior to connecting the NIRQuest Spectrometer, the Add New Hardware Wizard appears and installs the
NIRQuest Spectrometer drivers. If the drivers do not successfully install, or if you connected the NIRQuest Spectrometer to the
computer before installing the software, consult
Troubleshooting .
CAUTION
Ensure that TEC power is always applied (using OceanView software) before USB power.