Oce PlotWave 300, Руководство пользователя

Страница: 196 / 340

Make a copy and add a strip
Introduction
You can use a strip to file a drawing.
Use 'Sheet size' to copy an original without a strip and add a strip to the copy. You can
add a strip at the top or bottom side of a copy.
Use 'Erase margins' to copy an original with a strip and remove the strip from the copy.
You can erase a margin from the top, the bottom, the left or the right side of the original.
Before you begin
If you must enter the same value for a setting very often, you can set this value as the de-
fault value for that setting in the Océ Express WebTools.
After you press the start key, the user panel always shows the job number and status of
the job. A copy job appears temporarily in the 'Jobs - Queue' section of the Océ Express
WebTools, a scan job appears in the Smart Inbox 'Scans'.
How to make a copy and add a strip
1.
Feed the original face up and centered on the original feeding table.
Note:
You do not need to center the original precisely. The exact position of the original is au-
tomatically detected by the scanner.
The 'Copy' tab is automatically activated on the user panel.
2.
Open the 'Copy' tab with the confirmation button above the scroll wheel.
3.
Define the job settings.
#
'Add trailing strip' 'Add leading strip'
■
Open a template with the confirmation button.
■
Scroll to 'Sheet size' and open this setting with the confirmation button.
■
Scroll to 'Add leading strip' or 'Add trailing strip', define the value with the scroll
wheel or numeric keys and confirm.
4.
Define the number of copies and press the green button.
Chapter 5 - Use the printing system 196
Make a copy and add a strip