Oce Oce TDS800, Руководство пользователя

Страница: 62 / 281

62 Océ TDS800 User Manual
▼
Select accounting
1
Open the ‘Scanner’ card in the ‘Original’ section.
2
Select ‘Account id’ or ‘User id’ with the section key.
3
Set the needed ‘Account id’ or ‘User id’ with the ‘Arrow’ keys.
Using the manual feed for copy jobs
If you want to copy a job on a media type or size that is not available on one of
the media rolls, it can be convenient to manually feed cut sheets instead of
switching media rolls. The manual feed is a special slot just above the roll
drawers on the print engine. You can insert pre-cut copy material in this slot,
one sheet at a time.
Note:
Only use media as specified in ‘List of available material types and sizes’
on page 253.
▼
Copying on pre-cut sheets
1
Press the Manual feed key on the Scanner.
2
Select any required other settings.
3
Enter the number of copies using the numeric keys.
4
Feed the original. The printer display looks as follows:
[21] The printer operator panel with manual feed message
5
Press the start key.
6
Take your sheet of copy material to the side of the printer engine that contains
the Manual feed.
7
Use both hands to align the copy material in accordance with the format
indication and the sticker on the manual feed table.
8
Move the copy material forward in the nip of the roller. This must cause an
ample paper bulge over the full width of the page.
9
Hold the paper with both hands until the engine pulls in the first part of the
sheet.
The bulge will be reduced or it will disappear. A few seconds later the complete
sheet will be pulled in the printer.