Oce CS9350, Руководство пользователя

Страница: 108 / 194

CS9350 OPERATION MANUAL
5-108
Effect menu
Set up this menu when you want to improve print quality by adjusting the set Print Mode.
NOTE

The print quality may not be improved depending on the printing condition.
*1 The default value of the effect differs depending on the selected print mode as shown below.
Setup item Setting Description
Effect <None> *1 The Effect function is not used.
Wave The printing joint will be the wave form.
The print quality may be improved than None.
<Fog> *1 The printing joint will shade off.
Set up this menu when obvious white lines or uneven print density
appear on printed media in “Wave”.
Mode for low resolution (360 x 720dpi).
<Fine & Fuzz> *1 The printing joint will shade off as the wave form.
Perform the printing at slower speed than “Wave”.
<Fine & Fog> *1 The printing joint will shade off.
Set up this menu to improve horizontal banding with Fine & Fuzz.
Perform the printing at a slower speed than Fine & Fuzz.
A-S.Fine & Wave Performs “Wave” printing using the half of the print head nozzles.
Since only half of the print head nozzles are used, printing speed
becomes a half of “Wave”.
Set up this menu to improve the print quality compared with “Fine &
Fuzz”. If used when one side of the nozzles are clogged, quality
deterioration may be avoided.
B-S.Fine & Wave Performs “Wave” printing using the half of the print head nozzles on
the opposite side of “A-S.Fine & Wave”.
Since only half of the print head nozzles are used, printing speed
becomes a half of Wave.
Set up this menu to improve the print quality compared with “Fine &
Fuzz”. If used when one side of the nozzles are clogged, quality
deterioration may be avoided.
— •[Enter] key: saves the setting and shifts to the previous menu.
•[Cancel] key: cancels the setting and shifts to the previous menu.
5.1 Setup menu
Print Mode Effect Default Value
Quality1 to 4 Fine&Fuzz
Graphics1 to 2 Fine&Fuzz
Graphics3 to 4 Fine&Fog
Banner1 to 2 Fog
Banner3 to 4 None