Oce CS6407, Краткое руководство пользователя

Страница: 32 / 206

32
Troubleshooting
Inspection/check item Action
Power is not turned on. Connection of the power cord Plug the power cable properly into a power outlet.
Power supply to power outlet Supply power to the power outlet. Check whether proper
power voltage is supplied.
Power switch ON/OFF status Turn on the power switch.
The paper guide does
not heat after the
heater is turned on. Printer status The paper guide is heated during printing or when the heater
is turned on with the heater control menu. Print an image or
set the heater to ON to see if the paper guide is heated.
Host computer RIP setting The heater temperature can also be set by the RIP of the host
computer. Check the host computer setting.
Heater control menu Turn on the heater (postheater/print heater/preheater) again,
and then print an image or set the heater to ON to see if the
paper guide is heated.
Power voltage Connect the printer to 200 VAC power.
The printer does
not start or operate
normally. Error LED ON and LCD message Take appropriate actions according to the error message.
Printing is disabled. USB cable connection Connect the USB cable correctly.
Error LED ON and LCD message Take appropriate actions according to the error message.
Error LED OFF Print the test pattern.
(Confi rm that the RIP software "Test pattern" is printed.)
Print head cleaning Clean the print head.
Although the printer
is in the print mode,
printing does not start
with "PREHEATING"
displayed on the
operation panel. Room temperature Raise the room temperature. (Recommended temperature: 20
to 25ºC)
Aff ect of air fl ow If the air from the air conditioner or fan is blowing against the
paper guide, avoid the air fl ow (by changing air fl ow direction,
orientation of the printer or the location of the printer).
The transmitted data is
not printed. ONLINE LED (blinking?) Check the host computer communication conditions.
Blank sheet appears. Print data Check the current print data to see if blank sheet data is sent.
Media jam occurs
frequently. Media type Check whether the set media type matches the media type
setting.
Media installation Install the media properly.
Foreign matter in the carriage path Remove the foreign matter, if any.
Foreign matter in the media feed path Remove the foreign matter, if any.
Suction fan power If the suction fan power is not best set, reduce the power.
Heater temperature setting If the heater temperature is not best set, lower the heater
temperature.
Print speed is low. High-temperature environment If the printer temperature is higher than 40°C, the printer
prints media at a lower printing speed. Set the atmospheric
temperature to 20 to 25°C (recommended temperature) and
leave the printer for at least one hour, and then start printing.
USB transfer speed Check the USB transfer speed. When the USB connection is
made at the full speed, change the host computer connection
confi guration to high-speed USB connection to increase the
printing speed.
The menu is displayed
in another language. Language setting
Turn on the power switch while pressing the
M E N U
key
to start the printer. The language setting menu appears. Set
the language you want to use.