Oce CS 4040, Руководство по установке

Страница: 28 / 51

28 Océ CS 4040/4050 Installation Manual
9
Set the
Detail
window in the center of the
Overview
window in order to view
the lines clearly. The lines in the
Detail
window should resemble one of the
three shown as follows:
[7] Using the height adjustment chart
▼
To adjust the camera height
1
Slide the streamer at the front of the scanner to the left to access the camera
adjustment holes.
2
Use the screwdriver to turn the screw through the hole in the front of the
camera A hole (approximately 2.5 scanner units from the right) either
clockwise or counter clockwise until the horizontal line becomes a continuous
line. To update the screen, change the brightness and contrast setting between
0 and 1.
■
Clockwise:
Line on the right side of the screen moves up.
■
Counter clockwise:
Line on the right side of the screen moves down.
3
To adjust the camera C, set the
Detail
window centered about halfway in from
the left of the
Overview
window. Use the screwdriver through the camera C
hole (approximately 8.0 scanner units from the right) and turn until the lines
become continuous.
■
Clockwise:
Line on the left side of the screen moves up.
■
Counter clockwise:
Line on the left side of the screen moves down.
4
To adjust the camera D, select a
Detail
window centered about three-quarters
in from the left of the
Overview
window. Use the screwdriver through the
camera D hole (approximately 11.0 scanner units from the right) and turn until
the lines become continuous.
1 2 3 4 5 6 7 1 11 12 13 14 15 16 17 1 1 2 21 23 24 25 26 27 2 2 3 31 32 33 34 35 36 37 3 3 4
EIGT ALIGNMENT CART
PART NO. 6399A102
INSERT TIS EDGE AT
0
INSERT TE TEST CART
WIT TIS SIDE DOWN
INSERT TIS EDGE