Oce 7050, Техническое и сервисное руководство, Страница: 26 / 275

ed. 6 Installation 5
C
o
nf
ide
n
ti
a
l
©
Oc
é N
e
der
la
nd B.
V
. V
e
nlo
2
001
47
Mount the left and right brackets.
48 Mount the developing unit protection cover.
49
Mount the original feed table (1 screw).
50
Move the paper feed table upwards.
51 Close the right side cover (3 screws).
52 Close the left side cover.
53
Lift the protection cover and turn it to the front (put it in the groove).
Note:
Take care not to damage the seal.
54
Tighten the 2 screws of the protection cover.
55 Close the fuser unit.
56
When you are installing an Océ 7055/56, you must connect the cable between
the basic machine and the roll unit.
Note:
Don’t forget the tie wraps and earth connection
Toner sensor voltage adjustment
(
see ‘Toner sensor voltage adjustment (upto machine 705025000/705530000)’
on page 301
and
see ‘Toner sensor voltage adjustment (from machine
705025000/705530000)’ on page 302
)
57 Put the I-booklet in the holder and remove the pages which are not relevant for
this model.
58
Mount the paper guide strips below the copy exit. (See drawing)
59
Mount the original guides.
60
Ask the key operator to add toner.
61
Select the country setting Europe or USA with SDS test +0, -1 (See Faults
page 29 ).
62
Select the roll unit configuration (one roll or two rolls) with
SDS test +4, 0, -1 (See Faults
page 35 )
63
Make the following adjustments:
center of the machine (rear view)
approx.
160 mm
(6.3")
approx.
160 mm
(6.3")
approx. 264 mm
(10.4")
approx. 264 mm
(10.4")