Occhio 3d body pico, Инструкция по монтажу

Страница: 81 / 96

33
Insert the socket from the rear side of
the drilled hole.
The sleeve of the socket must end flush
with the visible surface of the panel.
If the sleeve protrudes, proceed as
follows…
…Shim the socket with enough spacers
until the sleeve ends flush with the vis-
ible surface of the panel.
When shimming, ensure that the spacer
pins lock into the holes provided.
3d pico plug (panel)
Caution:
The socket for the luminaire con-
nection cable must be inserted into
the protective cover.
Tape together the security wire and
LED cable just after the plug, as
shown in the illustration.
The cable and security wire can only
then be pulled out after fitting.
Connecting a converter from an
external manufacturer (see supple-
mentary sheet for the converter):
Lengthen the cable provided, if neces-
sary, and connect it to the external
converter.
Connect the converter to the mains
cable as shown in the wiring diagram.
Connect the cable with the LED socket
to the converter.
Observe the technical instructions of the
particular manufacturer.
Black = positive pole, white = nega-
tive pole
Screw the socket in place with three
screws (length: max. 14 mm).
Check the length of the screws.
Fit the panel.