A8814 Acq
Page 26
meter devices.
Firmware Update
The AcquiSuite can upgrade its own firmware using the firmware update page. The AcquiSuite must have an
Internet connection to communicate with the Obvius.com website for firmware updates. If a LAN connection is
present and configured, it will be used by default. If the AcquiSuite uses a dialout connection, you must first
enable the dialout by clicking the “dialout now” button on the Networking/Modem-ppp/Status page.
After clicking the “Check for updates” button, the AcquiSuite will contact the obvius.com webserver and attempt
to download a list of firmware files. The list is compared to the firmware versions installed, and a listing of the
files will be displayed. If any firmware updates are available, a button to the right will be shown labled
“Upgrade”. The firmware files are as follows:
asarm.cramfs The main AcquiSuite firmware file including the modbus and data logging software
usrarm.cramfs
High level system support files such as FTP, and timezone information
ramdisk.gz
Low level system files and system libraries
zImage
The Linux operating system.
a8812io.hex The analog/pulse io co-processor firmware.
When clicking on the Upgrade button, the AcquiSuite will again contact the obvius.com website and download
the requested firmware image file. The AcquiSuite will take a few seconds to verify the file checksum and prompt
you with an “Install” button. Click the install button and the AcquiSuite will install the firmware update and
reboot itself to make the changes take effect.
Do not power down the AcquiSuite during any step of the AcquiSuite firmware update process. Doing so may
corrupt the system and render the AcquiSuite unusable.
Diagnostics
Host Lookup
The Host Lookup page provides the ability to do some basic network tests. These are as follows:
Ping
: send an echo request to the specified host.
Traceroute
: Send an echo request to the target address and attempt to locate every router in between the
AcquiSuite and that address.
Nslookup
: convert the dns name to an IP address, useful for testing the functionality of the DNS server
configured in the Network/Setup webpage.
To run a network test, enter the ip address or dns name in the field provided, check the checkbox next to the test
you wish to use, and click the OK button. Multiple tests can be specified.
Connection Test
The connection test page will attempt to establish an HTTP session with the specified upload server. Click the
“begin test” to start this process. Information will be printed in black. Success responses will be printed in
Green, failure messages will be printed in Red. A sample upload test follows:
Ping localhost [127.0.0.1]:
Success
Ethernet IP address [192.168.10.50], mask [255.255.255.0]
Local subnet [192.168.10.0] to [192.168.10.255]
Ping ethernet ip address [192.168.10.50]:
Success
Starting system debug logger
Содержание AcquiSuite+ A8814
Страница 34: ...A8814 AcquiSuite Page 34 Mechanical Drawing...
