Observint NVR4020, Руководство пользователя

Страница: 92 / 125

84
4. Configure the following SNMP settings:
—
Trap Address : IP Address of SNMP host
—
Trap Port : Port of SNMP host
5. Click Apply to save your settings and close the menu.
NOTE
Before setting up SNMP, download the SNMP software and configure it to receive the device information via the SNMP port. By
setting the Trap Address, the NVR is allowed to send the alarm event and exception messages to the surveillance center.
7.2.5 Configuring Remote Alarm Host
With a remote alarm host configured, the NVR will send the alarm event or exception message to the host when an alarm is
triggered. The remote alarm host must have the Network Video Surveillance software installed.
1. Open the Network Settings menu. Go to
Menu | Configuration | Network
2. Click the More Settings tab to open the
More Settings
menu.
3. Enter the Alarm Host IP address and Alarm Host Port in the appropriate fields. The Alarm Host IP address is the IP address of
the remote PC on which Network Video Surveillance Software is installed. The Alarm Host Port must be the same as the alarm
monitoring port configured in the software.
4. Click Apply to save your settings and close the menu.
7.2.6 Configuring Multicast
Using the multicast function, more than 64 cameras are connectable. A multicast address spans the Class-D IP range of 224.0.0.0 to
239.255.255.255. We recommended that you use the IP address range from 239.252.0.0 to 239.255.255.255.
1. Enter the Network Settings interface. Go to
Menu | Configuration | Network
SECTION 7: NETWORK SETTINGS