Identifikationssystem OBID
®
Montageanleitung ID ZK.AB-A
FEIG ELECTRONIC GmbH
M00500.0de-ID-B.DOC
Seite 50 von 52
Appendix D: safety instructions – please read carefully prior to initiation
l
The device may only be used for the purpose intended by the manufacturer.
l
The operating instructions have to be handed out to every user and kept in an easily accessible place.
l
Unacceptable changes as well as the use of spare parts and special features which are not sold or
recommended by the manufacturer, may cause fire, electric shocks and injuries. Therefore, such
measures lead to nonliability of the manufacturer and a lapse of all warranty claims.
l
The appliance is subject to the manufacturer’s guarantee regulations in the version valid at the time of
purchase. We cannot be held liable for improper or faulty manual or automatic adjustment of parameters
resp. improper use of the appliance.
l
Please do only use VDE-certified leads for this connection.
l
For reasons of fire protection, we recommend to use only sources of current with a limited power output
of max. 8A.
l
Repair work may only be carried out by the manufacturer.
l
Installation, initiation, maintenance, measuring and adjustment of the appliance should only be carried
out by electricians with a good knowledge of the rules for the prevention of accidents.
l
Please switch off the power supply before opening the device and make sure that it is idle. The fact that
an operational display goes out does not necessarily mean that the device is disconnected from the
power supply and idle.
l
All labour that is carried out on the appliance as well as its initiation, has to conform to the national as
well as the local regulations. The user has to make sure that the appliance is installed and operated
according to the technical rules of the country of installation as well as other regional regulations. Cable
dimensions, protection, earthing, disconnection, insulation control and excess current protection should
be especially considered.
l
Mixed operation of low- and extra-low voltage at the relay output is not admitted.
l
In case of a forced removal of the reader, the control line (as far as the relay is used) of the door/gate
control may be shorted out and unauthorized opening becomes possible.
Appendix E: certification
If used properly, this radio plant conforms to the basic requirements listed in article 3 as well as to other
relevant requirements of the R&TTE-directive 1999/5/E6, dated March 1999.
