OBH Nordica Master Steel+ 7748, Инструкция по эксплуатации

Страница: 34 / 40

damages as a consequence of the above to the
product are not covered by the warranty.
Before use
Clean the appliance, jug, mug and lid as per the instructions under “Cleaning
and maintenance”. The blade unit is very sharp and must be handled with the
utmost care. The blade unit can be removed and washed separately.
Main components
(see illustration page 3)
1. Filler cap
2. Lid
3. Blender jug 1.5 litres
4. Blade unit
5. Seal (not shown in illustration)
6. Lock ring
7. Motor section
8. Switch/speed knob
9. Programme selection buttons
10. Seal (not shown in illustration)
11. Take-away mug 600 ml
12. Lid for take-away mug
Use
The blender can be used for blending, chopping, puréeing and mixing e.g.
milkshakes, baby food, soups and sauces. You can also crush ice for drinks,
etc.
Fit the blender jug/take-away mug to the motor section after cleaning by first
placing the seal around the blade unit. Then place the blade unit in the base of
the blender jug/take-away mug and then screw the lock ring onto the blender
jug/take-away mug.
Make sure the appliance is switched off and then place the blender jug/take-
away mug on the motor section so that the lock ring fits into the slots on the
motor section. Check to ensure that the jug/mug is straight and stable.
The blender motor moves the blade at high speed in order to guarantee
thorough mixing. It is important, therefore, that the blender is always placed
on a flat, dry surface before it is started. Also check that the blender jug/take-
away mug is correctly positioned on the motor section, otherwise the appliance
will not start. Remember to place the lid and filler cap on the blender jug before
starting the blender.
Fill the blender jug/take-away mug with the ingredients to be mixed (never
exceed the maximum limit of 1.5 l/600 ml) and place it on the motor unit.
34
7748_JG_0618.indd 34 2018-07-11 15:49:44