background image

P1PVKY / P1PVCDKY 

Installation & Service Instructions 

 

 
 

 

 

030099-347 

pg 14 of 14  

         © Copyright 2007 OASIS Corporation 

 

Remove the front door and the top from the cooler and disconnect the blue tubing that 
connects the bulkhead fitting on the back of the cooler to the plastic tee-piece (disconnect the 
tubing at the tee piece) 

 

Connect the blue tube to the inlet side of the Filter Cleaning Cartridge 

 

Using a 12” length of 

¼

” blue tubing, connect the outlet side of the Filter Cleaning Cartridge 

to the tee-piece 

o

 

If a filter system has been installed in the cooler, then use the Filter Cleaning 
Cartridge to bypass the filter system (i.e.disconnect the tube attached to the inlet to 
the filter system and fit it to the inlet of the Filter Cleaning Cartridge & disconnect 
the tube attached to the outlet to the filter system and fit it to the outlet of the Filter 
Cleaning Cartridge) 

 

Reconnect the cooler to the mains water supply 

 

Allow the reservoir to fill with water (leave for about 5 minutes) and dispense water from both 
the cold and ambient systems  to bleed all air from the system

 

 

Let the cooler stand with cleaning solution in it for 20-30 minutes.   

 

After the 20-30 minutes are up dispense water from both systems for 2 minutes to remove all 
traces of cleaning solution.  

 

Disconnect the cooler from the mains water supply and and remove the Filter Cleaning 
Cartridge 

 

Reconnect the blue tube to the tee-piece (or re-install the filter system) 

 

Reconnect the cooler to the mains water supply 

 

General Cabinetry Cleaning: 

 

It is recommended that the machine is cleaned once per week 

 

Turn off the power at the wall socket and remove the power cord at the rear of the machine. 

 

Wear clean rubber gloves to carry out the cleaning functions. 

 

Remove and clean the drip tray assembly. 

 

Clean all machine surfaces with non-abrasive vending machine cleaner/sanitizer. 

 

Replace the drip tray. 

 

Re-connect the machine and turn on the power and check for correct operation 

 
 
 

THIS APPLIANCE MUST BE EARTHED. 

This appliance is not suitable for unsupervised use by young children or aged and infirm persons. The warranty, 

Underwriter’s Laboratory certification and CE certification for this machine are automatically void if any alteration, 

modification, or combination with any other machine or device is deemed to be the source of any claim. The UL and CE 

certification may be void as the result of any alteration or modification. The manufacturer accepts no liability resulting from 

any alteration, modification, or combination with any other machine or device. 

 

EXCEPT AS SET FORTH HEREIN, THE MANUFACTURER MAKES NO OTHER WARRANTY, GUARANTEE, 

OR AGREEMENT EXPRESSED, IMPLIED OR STATUTORY, INCLUDING ANY IMPLIED WARRANTY OR 

MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. 

 

OASIS East Sp.z o.o. 

Gutenberga 20 str 

44-164 Gliwice SEZ, Poland 

Tel:   +48 32 332 6501   ;   Fax:  +48 32 332 6500 

www.oasis.ie

 

Содержание P1PVCDKY















Отзывы: