Oasis Aquatics Oasis SE Series, Инструкция по установке и эксплуатации

Страница: 10 / 20

SE SERIES SINGLE-ELEMENT CARTRIDGE FILTER INSTALLATION AND OPERATION MANUAL Page 9 of 19
6. MAINTAINING YOUR FILTER
FILTER DISASSEMBLY INSTRUCTIONS
1. Switch off all pumps and electrical power in pool equipment area.
2. Set any pool system valves in a position that prevents water from flowing to the filter.
3. Loosen the air relief valve approximately one and a half turns.
4. Remove the filter drain plug to release all water from the filter.
5. Depress the latch and unscrew the lock ring counter clockwise.
6. Lift and remove upper filter body.
REMOVING CARTRIDGE
1. Remove the filter cartridge element by using a slight rocking motion and lifting.
2. Clean filter cartridge element.
CLEANING CARTRIDGE
The cartridge filter element can be washed inside and outside by a garden hose. After hosing the cartridge,
for best results, carefully brush the pleated surface to remove fine particles. Do not use high-pressure
water to wash as it can damage the filter element.
You may find some debris on the cartridge pleats, which cannot be removed with hosing. From time to
time, the filter element will require a deep clean using a purpose-specific cleaning solution that can be
purchased from most pool shops. Follow the instructions provided by the pool shop or solution
manufacturer to achieve the best result.
FILTER REASSEMBLY INSTRUCTIONS
RE-INSTALLING CARTRIDGE
1. Clean any debris from the lower filter body.
2. Reinstall the filter drain plug.
3. Install the cartridge element.
4. Clean and lubricate the upper body o-ring with
silicone-based grease.
5. Install the upper body and push down until o-ring
seats.
6. Install the lock ring by tightening clockwise until
the latch clicks into the locked position.
7. Reset any previously adjusted pool system
valves.
8. Switch on filter pump. When pump starts, do not
stand over or near filter.