Oasis Aquatics CX15, Инструкция по установке и эксплуатации

Страница: 26 / 34

CX Chlorinator - Salt and Mineral Operation MANUAL Page 25 of 33
Fault Indication Potential Cause Remedy
10.18 Cell not cleaning,
excessive calcium build-up
on Cell or Power Pack not
changing direction
Excessively high calcium,
change
of direction time set too high
or
faulty PCB 1. See Calcium Hardness test (sec 8.5)
and adjust water accordingly
2. Change the Cell Cleaning times
(sec. 7.3)
3. Manually try changing direction
buttons in for 3 sec (you must be in the
default display screen for this to work).
Failure for this to work could indicate a
faulty PCB - return for service
10.19 Low or No Chlorine Output
Unit not working correctly Go through Troubleshooting from 9.1
Stabiliser is too low Check Stabiliser guide (sec 8.6)
Unit not set correctly Basic settings such as Output Control and
Timer running hours need to be checked
Go through all settings in sec. 5, 6
& 7 and balance water accordingly
Salt level is too low Check Salt guide (sec. 6.6/8.2)
pH is too high Check pH guide (sec. 8.3)
Cell at the ends of its life If full output is not reached, then it could be
a failing Cell
10.20 Timer loses time when
mains power removed
Battery life expired Replace Battery - return for service
DISCLAIMER : Information in this guide is intended to provide general information on a particular
subject(s) in good faith and is not an exhaustive treatment of such subject(s). Its use is beyond the
control of the author, contributor, publishers, licenced professionals and under no circumstances should
the guide be used as a substitute for such professionals. No representations or warranties are made
that the content, advice and recommendations in this guide are current, free from errors or omissions,
or ap
propriate for the user’s circumstances or abilities. No liability or responsibility is accepted persons
or OASIS AQUATICS Pty Ltd appointed agents. OASIS AQUATICS Pty Ltd reserves the right to
refuse warranty if any damage caused to the chlorinator or auxiliary pool equipment that is not a result
of a manufacturer’s defect.