![background image](http://html1.mh-extra.com/html/oase/icefree-thermo-330/icefree-thermo-330_translation-of-the-original-operating-instructions_3148101009.webp)
- EN -
9
Safe operation
•
Only operate the unit if no persons are in the water.
•
Never operate the unit if either the electrical cables or the housing are defective!
•
Do not carry or pull the unit by its electrical cable.
•
Route cables/hoses such that they are protected from damage and do not present a tripping hazard.
•
Only open the unit housing or its attendant components, when this is explicitly required in the operating instructions.
•
Only carry out work on the unit that is described in this manual. If problems cannot be overcome, please contact an
authorised customer service point or, when in doubt, the manufacturer.
•
Only use original spare parts and accessories for the unit.
•
Never carry out technical modifications to the unit.
•
Keep the socket and power plug dry.
•
Never remove the legends from the unit or the connection cables.
Installation
Attention! Dangerous electrical voltage.
Possible consequences:
Death or severe injury.
Protective measures:
•
Electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the water: Isolate the
units and installations (switch off and disconnect from the power supply) before reaching into the water.
•
Isolate the unit before starting any work.
•
Secure the unit to prevent unintentional switching on.
How to proceed:
A, B, C
•
Place the heating element in the centre of the float.
Note: The heating element can only be inserted into the float in one position.
•
Place the unit in the water.
•
Route the power cord safely (
→
Correct electrical installation in accordance with regulations). Minimum distance of
the power socket from the water: 2 m.
Note!
•
Only use the unit during periods when there is a risk of freezing.
•
Remove the unit when there is no risk of freezing.
Commissioning/start-up
Attention! Hot surface. The heating element becomes very hot during operation.
Possible consequence:
Risk of burns in the event of contact.
Protective measures:
•
Do not connect the unit to the power supply until the unit is in the water and the heating element is immersed.
•
Before performing any work on the unit, ensure that it is disconnected from the power supply and wait for
several minutes until the heating element has cooled down.
Switching on:
Connect the unit to the mains. The unit switches on immediately.
Switching off:
Disconnect the unit from the mains.
Содержание IceFree Thermo 330
