Oase AquaMax Eco Titanium 50000, Руководство по эксплуатации

Страница: 11 / 16

- EN -
18
Maintenance and cleaning
Attention! Dangerous electrical voltage.
Possible consequences:
Death or severe injury.
Protective measures:

Electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the water:
Isolate the units and installations (switch off and disconnect from the power supply) before reaching into
the water.

Isolate the unit before starting any work.

Secure the unit to prevent unintentional switching on.
Cleaning the unit
Note!
Recommendation on regular cleaning:

Clean the pump as required but at least twice a year.

Never use aggressive cleaning agents or chemical solutions. These could attack the housing surface or impair the
function.

Recommended cleaning agent for removing stubborn limescale deposits:
– Pump cleaning agent PumpClean from OASE.
– Vinegar- and chlorine-free household cleaning agent.

Clean the outside of the pump.
– Use a soft brush as an aid.
– The formation of a thin layer of rust is normal and does not negatively affect the function.

After cleaning, thoroughly rinse all parts in clean water.
Replacing impeller unit
Note!
The impeller unit is guided in the motor block by a bearing. This bearing is a wear part and should be chan-
ged at the same time as the impeller unit.

Changing the bearing requires specialist knowledge and tools. Have the bearing changed by your OASE
specialist dealer or send the pump to OASE.
Note!
The impeller unit contains strong magnets that attract magnetic particles (e.g. iron filings).

All particles must be removed from the impeller unit before reassembly. Any remaining particles can cause
irreparable damage to the impeller unit and motor block.
Prerequisite:

The pipes at the inlet and outlet are removed.

Protection against injury: The protection caps are fitted to the inlet and outlet.
How to proceed:

H
Remove the screws and remove the pump from the stand.
Remove the four screws and take off the pump casing.
Pull out the impeller unit and replace if necessary.
– Use a wide-blade screwdriver to carefully lever out the impeller unit if necessary.
Reassemble the unit in the reverse order.