DIRECTIONS FOR USE
CARBON FIBER ARM BOARD (ACCESSORY)
CAUTION
Do not place undue weight or downward pressure on the Carbon Fiber Arm Board. It is a posi-
tioning device for the arms and should not be used as leverage to get on or off the table. Injury
can occur. DO NOT exceed 30 lbs. (14 kg.) of load on the
Support Section.
Injury can occur.
Use
This radiolucent device can be used with any flat support surface where ionizing radiation (x-ray) is utilized for imaging.
It can be used to support arms and feet.
Directions
Unfold the Arm Board and slide the
Base Section
under the patient and the table pad. Position the patient and the
Support Section
to suit the needs of the procedure. The weight of the patient will hold the Arm Board in place.
Rotate the
Support Section
to the desired position. This section rotates up to 180º.
To remove the Arm Board, ask the patient to move their limb off the
Support Section
and lift their body slightly. This
will allow you to pull out the base section of the Arm Board.
Fold the
Base and Support sections
for storage.
Prone Position at 135º
Supine Position at 180º
Support Section
Base Section
ADJUSTABLE T-RAIL CLAMP USE (ACCESSORY)*
1. The clamp must be installed only on an Oakworks
®
CFPM product with the groove on the underside of
the table.
2. Slide the clamp in the groove to the desired position
on the table top.
3. Ensure the lower part of the clamp is aligned with
and in the groove of the table top. Tighten the clamp
using the handle.
4. Attempt to slide the clamp. Ensure the clamp will not
move and is secured tightlghtly to the tabletop.
5. The handle can be rotated without loosen up the
clamp. To move the handle out of your way, lift the handle up and rotate towards the inside of the
table, then release the handle to reengage. The handle can then be used to tighten or loosen the
clamp and slide to a different position on the tabeltop.
Note: The Integrated T-Rails are US standard size of .38” (1cm) thick by 1.13” (3cm) wide.
CAUTION
Recheck tightness of T-Rail Clamp in between proceudres.
Ensure that the lower part of the clamp is in the tabletop groove under the table top.
Ensure the T-Rail Clamp is tight and can not move with pressure.
23
