OAKWORKS Celesta Gemini CLODAGH, Инструкция по эксплуатации

Страница: 24 / 36

16
TROUBLESHOOTING
• If
C
elesta
G
emini ™
will not Change Height or Position
• Hand Control Replacement
T
R
O
U
B
L
E
S
H
O
O
T
IN
G
I
F THE
C
ELESTA
G
EMINI
™
WILL NOT CHANGE HEIGHT OR POSITION
:
• Check the outlet to be sure that it has power and that the power
cable is plugged in. Try each Foot Control and Hand Control to
see if any work. If any work, then possibly there is a loose connection
or a faulty controller.
• Unplug the power cable from the wall outlet.
• Make sure that all male and female connectors are firmly
pushed into each other. Even a slight misconnection can
cause a possible malfunction.
• Plug the unit back into the wall and check the controls
again. If one or more of the controls still do not work,
contact Customer Service at 800-558-8850 to arrange
replacement. After receiving replacement for the needed
control then proceed to the section describing the replacement
of the inoperative control.
HAND CONTROL REPLACEMENT INSTRUCTIONS
Replacement of the Hand Control may be necessary if the Hand
Control does not actuate the functions of height adjustment or
table top positioning.
To Replace the Hand Control, follow these steps:
1. Obtain the new Hand Control. (see Parts List, pg. 27)
2. It is recommended that the table be raised to a high height level
(use foot control) if possible, as you will need to drop the
control box out from beneath the cabinet. You will need about
14" of space to work easily.
3. After raising the table, disconnect the table’s power cord from
your power outlet before proceeding.
TROUBLESHOOTING
CAUTION
The table weighs as much
as 300 lbs.
DO NOT lift or
move the unit without using
proper safety procedures
or equipment.
DO NOT turn
the
C
elesta
G
emini ™
on its side
for any reason. To do so
could cause damage to the
base and
will void the warranty.
There are no serviceable
items that require this action.
Never lift the table by grasp-
ing the table top as the
table top is not designed to
hold the weight of the base
and you could damage the
table.
IMPORTANT
NOTE:
The new electronic
component will be
reinstalled in the same
manner as the old one.
When dissembling please
take note of the order,
installation method and
placement of plugs as
the new unit will be
reassembled in the
same way.
CAUTION
Before doing any work on the
unit,disconnect the power
cord from the power outlet.
Be sure to read all
cautions, warnings
and instructions given
in the manual to prevent
injur y to both operator
and client.
8
• Controls
8