Oakton WD-35610-00, Инструкция по эксплуатации

Страница: 4 / 29

4
Conductivity meter
CON 500
ON/OFF
MEAS
MODE
HOLD
SET
MI
MR
▲
▼
CAL
RANGE
ENTER
1. Introduction
Thank you for selecting the OAKTON
®
WD-35610 series
economy conductivity benchtop meter. This meter has
advanced microprocessor programming to give you state
of the art features at a low price.
The primary display shows the measured conductivity
reading in µS or mS and the secondary display shows the
temperature of the reading in °C. Both displays show self-
diagnostic messages, keypad functions and program
functions. Your meter also includes conductivity probe
WD-35607-50 with built-in temperature sensor and cable.
Keypad Functions
See Figure 1, right.
The keypad is easy to use.
Key Description
ON/OFF
Powers and shuts off the meter. Meter
enters measurement mode when turned on.
HOLD
Freezes the measured readings. To activate,
press HOLD while in the conductivity
measurement mode. To release, press
HOLD again.
MODE
Selects between the conductivity and the
temperature mode.
CAL/MEAS
Selects between Measurement and
Calibration modes.
ENTER/RANGE
In Measurement mode; selects range or
sets units to auto ranging. In Calibration or
Setup mode; confirms your values.
MI/
▲
In Measurement mode, MI inputs values
to memory. In Calibration mode and Setup
programs,
▲
scrolls up to the calibration or
set up values you want.
MR/ ▼
In Measurement mode, MR recalls stored
values from memory. In Calibration mode
and Setup programs,
▼
scrolls down to the
calibration or set up values you want.
SET
Enters the SETUP program.
Figure 1
ON/OFF
MEAS
MODE
HOLD
SET
▲
▼
MR
MI
CAL
RANGE
ENTER
warranty/
return of items
appendix
accessories
specifications
error
messages/
troubleshooting
probe care
and
maintenance
setup
program
conductivity
measurement
temperature
calibration
conductivity
calibration
starting up
introduction