OAK SCSI 4, Руководство пользователя

Страница: 13 / 54

I nstalling the Podule
(300/400/R140 Series Machines)
Disassembly
Unplug the mains power cord and all peripherals (including the
keyboard) from the Archimedes. The cover of the Archimedes is held
in place by 5 screws, three on the rear of the case above the podule
slots, and one at either side of the case close to the moulded plastic
front piece (as shown below). Remove all 5 screws and slide the lid
rearwards and off.
Positioning
The SCSI podule may be fitted in any of the four possible podule
positions. Remove the blanking plate related to your chosen podule
position from the rear of the Archimedes by undoing the screw at each
side. If you have removed a double width blanking plate, use the single
width blanking plate, T-Piece and screws supplied with your SCSI
card to build the podule backplate up to double width.
Carefully insert the SCSI card (component side up) into the desired
backplate socket on the Archimedes, making sure that the SCSI card is
held horizontally. The backplane is supported by a stout metal strip;
however it is wise to give the backplane additional support with one
hand whilst inserting the SCSI card. If there are no other podules fitted
in the Archimedes, it may be necessary to loosen the two screws at the
ends of the metal strip that reinforces the backplane, and carefully
reposition the backplane so that the SCSI card can be mounted flush
with the back of the Archimedes. Fasten the podule backplate
assembly to the back of the Archimedes with a screw at each end and
tighten the screws securing the backplane.
Page 6