18
IMPORTANT: For your own safety, we recommend that you have the brake lever installed
and adjusted in a bicycle workshop by a qualified technician in accordance with these in
-
structions.
IMPORTANT: For assembly steps that require a specific torque, always use a torque wrench
that can indicate the required torque with sufficient accuracy.
CAUTION: Risk of falls, accidents, injury or death if the above recommendation is not followed.
Note: The OAK Components GmbH is not liable for any personal injury or property damage re-
sulting from improper installation or adjustment of the Root-Lever or brake system, or failure to
follow instructions in this User Manual.
Step 1: Prepare the required tools and utensils
Lay out the tools and utensils on a flat, stable work surface. Hook the bike into an assembly
stand or otherwise secure it to prevent it from rolling away. The tools and utensils listed
below are required to install the Root-Lever Pro:
1.
TX 25 bit / Torx T25 key
2.
Hex socket wrench, 1.5mm and 2mm
3.
Hammer / rubber hammer
4.
Punch, Ø < 4 mm
5.
Bleeding kit for Magura brakes
6.
Wrench with 8mm opening width
7.
Line cutter / wire cutter
8.
Torque wrench, adjustment range 3 Nm to 4 Nm
9.
Isopropanol or other cleaning alcohol
10.
Knock-out device
11.
Clean rags
12.
Grease
For the production of a knock-out device, in case you do not have the lever exchange tool
available, you will need the following tools:
13.
Electric screwdriver
14.
Wood drill, Ø 5 mm
15.
Wooden board, at least 18 mm thick
Note: The bleeding kit for Magura brakes (item 5.) also contains several Magura olives and the
Magura hose barps. They are also part of every Magura brakes ystem you purchase.
