NXP Semiconductors
UM11705
PCF85063TP-ARD evaluation board
7. Install GUI application on the PC (see the instruction file referred in the above step);
8. Open the GUI application to operate the device from the PC. For details regarding
GUI operation see Section 8 “GUI description”;
Figure 8. PC85063TP-ARD daughter board / i.MX 8M Mini LPDDR4 EVK board operation
6.4 Using PCF85063TP-ARD with another device
The PCF85063TP-ARD daughter board can be operated with other EVK board, which
has an Arduino port. There are two options to connect the board: using other EVK
equipped with an Arduino port, and an EVK without Arduino port. In the first case, a
firmware shall be developed according with PCF85063TP specifications, and then simply
attach PCF85063TP-ARD daughter board to the EVK, to operate the board. In the
second case, using the pin chart of Arduino connectors (
), make the necessary
electrical connections (for power, I
2
C-bus and control lines), and develop the desired
firmware, assuring that it is compliant with IC specifications. Use PCF85063TP datasheet
to read details about internal registers of the DUT IC and data exchange between internal
controller and the EVK. Assure for correct electrical connections and avoid data conflicts
on the signal lines, to prevent IC damage.
7 GUI description
A GUI application is available for the three EVK boards from NXP Semiconductors.
The application is common for all EVKs and the development boards of the RTC family,
produced by NXP Semiconductors (PCF85063TP, PCF85063A, and PCF85263A).
UM11705
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2021. All rights reserved.
User manual
Rev. 1.0 — 19 November 2021
17 / 24