NXP Semiconductors
UM11705
PCF85063TP-ARD evaluation board
and for the RTC development board family, manufactured by NXP (PCF85063TP-ARD,
PCF85063AT-ARD and PCF85263ATL-ARD).
For details regarding installation of the EVK firmware and GUI host software on PC
please download EVK_Firmware_And_GUI_Install_Guide_For_Arduino_Boards.pdf
instruction file from NXP site (
). Once the software is installed, the first
step is to select the correct combination EVK – PCF85063TP-ARD daughter card, and
then the board can be controlled from the GUI interface. See
and
for
more details regarding the operation of PCF85063TP-ARD from GUI software.
6 Configuring the hardware
6.1 Using the PCF85063TP-ARD with an IMXRT1050 EVK board
shows the required hardware for operation of the PCF85063TP-ARD daughter
board with IMXRT1050 EVK. The following items are necessary:
•
One IMXRT1050-EVK board
•
One PCF85063TP-ARD daughter board
•
One USB-A / USB Micro-B cable
•
A PC with Windows 10 operating system
The IMXRT1050 EVK mother board can be powered by one of the three methods:
•
Connecting an external 5VDC power supply to the barrel power connector (J2) on the
board
•
Connecting a USB cable from the PC to the Micro-B USB connector (J9) on the board
•
Connecting a USB cable from the PC to the USB connector (J28) on the board. When
the PC is connected in this fashion, the USB port can simultaneously act as a debug
interface. Therefore, by using a single USB cable connected to J28, the EVK can be
powered and at the same time linked to the PC for data exchange.
The older USB ports (from PC) are not able to deliver the necessary current (500mA),
before establishing the communication, use an external power supply (connected to J2).
From J1 on the EVK board (see
) the user can select the power configuration
for the mother board. For further details, refer to the
UM11705
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2021. All rights reserved.
User manual
Rev. 1.0 — 19 November 2021
11 / 24