NXP Semiconductors PCF85063TP-ARD, Руководство пользователя, Страница: 12 / 24

NXP Semiconductors
UM11705
PCF85063TP-ARD evaluation board
Figure 3. PCF85063TP-ARD daughter board and IMXRT1050 EVK board, before starting
To configure the hardware and workstation, complete the following procedure:
1. Configure the suitable power configuration of EVK (J1). If using J28 for power supply,
the J1 jumper shall be placed in position 5-6. If using an external power supply
(connected to J2), the jumper J1 will be placed in position 1-2.
2. Insert the PCF85063TP-ARD daughter card on the Arduino connector of the EVK
(see Figure 4 ).
3. Using USB connector J28, connect the EVK board to a USB port of the computer.
4. Install the IMXRT1050 target firmware (download from NXP site and see UM11581,
Arduino Arduino shields GUI and firmware installation manual for step-by-step
instructions).
5. Install GUI application (see UM11581, Arduino shields GUI and firmware installation
manual ).
6. Open the GUI application to operate the device from the PC. For details regarding
GUI operation see Section 7 .
Figure 4 shows the boards during the operation.
UM11705 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2021. All rights reserved.
User manual Rev. 1.0 — 19 November 2021
12 / 24