NXP Semiconductors OM13260, Руководство по установке, Страница: 9 / 71

NXP Semiconductors
UMxxxxx
Install Guide
All information provided in this document is subject to legal disclaimers.
Preliminary 1
— September 6, 2013
© NXP B.V. 2013. All rights reserved.
9 of 70
4. First time setup: Fm+ Development Board Kit (OM13320)
4.1 Before You Begin
To use the Fm+ Development Kit (OM13320) for the first time requires some hardware set up and
installation of both firmware (on the Fm+ Development Board OM13260) and software on the
attached computer.
The following four steps must be completed:
1. Install Jumpers on the Fm+ Development Board (OM13260) (see section 4.3)
2. Install the USB Driver on the computer to be used with the kit (see section 4.6)
3. Install Firmware on the Fm+ Development Board (OM13260) (see section 4.7)
4. Install the NXP GUI Software on the computer to be used with the kit (see section 4.8)
There are two distinct operating modes each requires different firmware on the Fm+ Development
Board (OM13260).
It is recommended to install the “Trade Show” mode first, as this is an easier learning curve. Then
remove and replace it with the NXP GUI Firmware.
4.2 First time set up of the Fm+ Development Board (OM13260)
Several jumpers must be installed before using the Fm+ Development Board (OM13260) PCB. The on
board microcontroller (MCU) must contain the appropriate firmware. There are two distinct
applications (“Trade Show” mode and GUI mode) which require different firmware.
To replace the firmware requires the connection to a Personal Computer (PC) running Microsoft
Windows 7/64 Operating System and a USB port
4.3 OM13260 Jumpers
The Jumpers and their function are shown in Table 4.1 Using figure 4.1 and the table data install the
jumpers.