NXP Semiconductors MC56F80000-EVKUM, Руководство пользователя, Страница: 8 / 26

NXP Semiconductors
MC56F80000-EVKUM
MC56F80000-EVK Board User Manual
Part
identifier
Switch
type
Description
SW3 Push
button
SW3 connects to GPIOE7 when jumper J18 is shorted. Pressing SW3 gives a low level on
GPIOE7, otherwise, it is a high level on GPIOE7.
SW4 Push
button
SW4 connects to GPIOF8 when jumper J21 is shorted. Pressing SW4 gives a low level on
GPIOF8, otherwise, it is a high level on GPIOF8.
SW5 Push
button
SW5 connects to GPIOC13 when jumper J22 is shorted. Pressing SW4 gives a low level on
GPIOC13, otherwise, it is a high level on GPIOC13.
Table 5. Push buttons
...continued
1.8 Connectors
Connectors are onboard devices that allow to connect external devices to the board.
Figure 3 shows the MC56F80000-EVK connectors. The table below describes the
connectors.
Part
identifier
Connector type Description Reference section
J1 2x8 connector
J2 2x10 connector
J3 2x8 connector
J4 2x6 connector
I/O headers compatible with the Arduino shields Section 2.9
J7 DC power jack For 5 V input power supply to the board; connects to 5
V power adapter.
Section 2.1.1
J10 2x7 connector JTAG connector to program and debug the MC56
F80748.
Note:
Remove four jumpers on J13 when this JTAG
connector is used. This is to avoid the impact of
onboard OpenSDA circuit.
Section 2.12.1
J12 USB 2.0 micro-AB
connector
OpenSDA USB port, and external 5 V power connector.
Used for virtual serial communication and to debug/
program MC56F80748.
Section 2.8
J14 2x5 connector K26 (OpenSDA) JTAG/SWD connector. Provides debug
interface to program and debug MK26FN2M0VMI18.
See board schematic
J26 USB 2.0 micro-AB
connector
USB connector for USB-to-UART CP210x device,
which provides a virtual serial port. Also, used as an
external 5 V power connector.
Note:
CP210x USB-to-UART bridge VCP drivers are needed.
CP210x is not populated by default on the board.
Section 2.11
Table 6. MC56F80000-EVK connectors
1.9 Jumpers
Jumpers (or shorting headers) are small connectors that allow to choose from two or
more options available. Figure 3 highlights the MC56F80000-EVK jumpers available for
use. The following table describes the jumpers available on MC56F80000-EVK.
MC56F80000-EVKUM All information provided in this document is subject to legal disclaimers. © 2022 NXP B.V. All rights reserved.
User manual Rev. 1 — 14 December 2022
8 / 26