NXP Semiconductors
MC56F80000-EVKUM
MC56F80000-EVK Board User Manual
Pin
Signal
Pin
Signal
2
GPIOC12 (RXD1)
1
Not connected
4
GPIOC11 (TXD1
3
GPIOC6 (ENC_I/XB_IN3)
6
GPIOF5 (GF5/XB_OUT9)
5
Not connected
8
GPIOF4(GF4/XB_OUT8)
7
Not connected
10
GPIOC4/OPA_OUT
9
Not connected
12
GPIOC15 (ANA4c)
11
Not connected
14
GPIOC7 (SS0/XB_OUT6)
13
Not connected
16
GPIOC5 (ANB4d)
15
Not connected
Table 16. J1 (2x8-pin) connector pinout
Pin
Signal
Pin
Signal
2
Not connected
1
GPIOF1 (ENC_B/XB_IN7)
4
VDD
3
GPIOE7 (ENC_A/XB_IN5)
6
GD4 (RESET)
5
GPIOE4/PWMA_2B
8
VDD
7
GPIOE5/PWMA_2A
10
P5V
9
GPIOE2/PWMA_1B
12
GND
11
GPIOE3/PWMA_1A
14
GND
13
GPIOE0/PWMA_0B
16
P5V_DC_IN
15
GPIOE1/PWMA_0A
Table 17. J3 (2x8-pin) connector pinout
Pin
Signal
Pin
Signal
2
ANA3/B3
1
Not connected
4
GPIOA4 (ANA4)
3
Not connected
6
GPIOA5 (ANA5)
5
Not connected
8
GPIOB1 (ANB1)
7
Not connected
10
GPIOB4 (ANB4)
9
Not connected
12
GPIOB5 (ANB5)
11
Not connected
Table 18. J4 (2x6-pin) connector pinout
2.10 Arduino compatibility
The Input/Output headers (J1, J2, J3, J4) on the MC56F80000-EVK board are arranged
to enable compatibility with peripheral boards (known as shields) that connect to Arduino
and Arduino-compatible microcontroller boards. The outer rows of pins (even-numbered
pins) on the headers share the same mechanical spacing and placement with the I/O
headers on the Arduino Revision 3 (R3) standard.
2.11 USB-to-UART interface
The MC56F80000-EVK board supports the USB-to-UART function through OpenSDA
circuit and CP2102N device.
MC56F80000-EVKUM
All information provided in this document is subject to legal disclaimers.
© 2022 NXP B.V. All rights reserved.
User manual
Rev. 1 — 14 December 2022
21 / 26