JN517x-DK005
Development
Kit
User Guide
JN-UG-3121 v1.1
© NXP Semiconductors 2017
57
Note the following:
The ‘USB to Micro USB’ cable allows the board to be powered from a USB port
on the 5V DC PSU.
The Raspberry Pi must be located near to the mains outlet socket in which the
PSU is plugged and the PSU/socket must be easily accessible.
A JN5179 USB Dongle can be plugged into any of the USB ports of the
Raspberry Pi board to form an IoT Gateway (see
). However, it is
recommended that this connection is made via a supplied USB-to-USB cable,
especially when the Wi-Pi adaptor is also used (in order to ensure radio
isolation between the dongle and adaptor).
The JN5179 USB Dongle that is to be connected to the Raspberry Pi board for
the ZigBee Smart Home Demonstration is the one with a green sticker (see
). This dongle is pre-programmed as a Control Bridge.
The Wi-Pi wireless adaptor can be connected to any of the USB ports of the
Raspberry Pi board in order to provide Wi-Fi connectivity. However, it is
recommended that this connection is made via a supplied USB-to-USB cable,
especially when a JN5179 USB Dongle is also used (in order to ensure radio
isolation between the dongle and adaptor).
The supplied NFC Controller (see
) can be connected to the
Raspberry Pi board to facilitate NFC commissioning (see
).
The IoT Gateway software and documentation are available two Application
Notes:
ZigBee IoT Gateway Host with NFC (JN-AN-1222)
and
ZigBee IoT
Gateway Control Bridge (JN-AN-1223).
PSU Specifications
The supplied 5V DC PSU is a Stontronics T5454DV Raspberry Pi Power Supply and
its specifications are as follows:
Input
Input Voltage Range: 90-264V AC
Input Frequency: 47-63Hz
Input Current: 0.3A Max
AC Inlet: UK, European, Australian and US changeable heads
Output
Output Voltage: +5V DC
Minimum Load Current: 0A
Nominal Load Current: 2A
Nominal Output Power: 10W
Protection: Short circuit, over current, over voltage
Output Cable: 1500mm Micro USB B 5 pin
Other
Operating Temperature: 0°C to 50°C
Certification
CE, FCC, RoHS
