NXP Semiconductors JN517x-DK005, Руководство пользователя

Страница: 28 / 67

Chapter 2
ZigBee Smart Home Demonstration
28 © NXP Semiconductors 2017 JN-UG-3121 v1.1
2.3 Commissioning Nodes
This section describes how to complete the set-up of the ZigBee Smart Home
Demonstration by adding nodes to the ZigBee network by means of NFC
commissioning.
You will add two nodes to the network already established by the Co-ordinator
(JN5179 USB Dongle):

Dimmable Light

Dimmer Switch
These nodes are made up from components of the kit, as detailed in Section 2.1 .
The NFC commissioning of each node into the ZigBee network is identical. It is
performed by simply holding the NFC antenna of the node’s Carrier Board (see
Appendix A.1 ) above the NFC antenna of the NFC Controller (mounted on the
Raspberry Pi board) while the Raspberry Pi is in commissioning mode - this action is
known as an ‘NFC tap’ and is shown in
Figure 11 . An audible signal is sounded if the
NFC communication between the two devices was successful, after which the node
will join the ZigBee network.
Note: This section assumes that you have set up the
IoT Gateway as detailed in Section 2.2 .
Figure 11: NFC Tap