NXP Semiconductors JN516x-EK001, Руководство пользователя, Страница: 50 / 86

Chapter 3
Smart Home Demonstration
50 © NXP Laboratories UK 2015 JN-UG-3093 v1.5
b) On the PC, refresh the web page showing the Whitelist tab in the browser by
clicking on this tab. The new node should now appear in the list but will be
unticked (greylisted). If the node fails to show in the list, you are advised to power
off the board (e.g. remove the batteries) and re-start it (from Step 8a).
c) Make a note of the node’s IPv6 address and relate it to the physical node, for
identification purposes later on (you may wish to label the node with the address).
d) Put the node into the whitelist by ticking its checkbox on the left-hand side.
e) Click the Save & Apply button. The node should now be able to join the network.
Step 6 Use the Remote Control Unit to control the lights on the boards
a) Press the Wake (blue circle) button, located below the keypad, to wake up the
sleeping Remote Control Unit.
b) Enter a command sequence on the keypad - for example:

To switch off all the lights in the network, enter: * O

To switch on all the lights in the network, enter: * I

To dim all the lights in the network, enter: * - (hold down the ‘-’ key)

To brighten all the lights in the network, enter: * + (hold down the ‘+’ key)
Note: If the Remote Control Unit has been previously
used, it will remember the last network to which it
belonged. To clear this information and return to the
factory settings, enter the following key sequence into
the unit:
# O - O
Note: All the available key operations and command
sequences for the Remote Control Unit are listed and
described in
Appendix A.