NXP Semiconductors
Quick start ADC1610S series (F1 or F2 versions)
Quick start
© NXP B.V. 2011. All rights reserved.
Quick start
Rev. 5 — January 2011
18 of 28
Column 1
Column 2
20
0e
21
00
22
00
Note that all data are saved in hexadecimal format.
Click on the “Save registers read to file” button to select the file to store data to. Make sure that you
store your file with “.txt” extension, this will allow you to re-use the file on the “ADC - Load
Registers” page.
3.3.3 ADC SPI programming Load Registers page
This page allows downloading configuration data to the device registers:
It is not necessary to have a file that has the whole set of registers listed. The only restriction is
regarding the formatting of the file as given in
section 3.3.2
.
Note: this page cannot be used to download data saved during the comparison process.
To download settings onto device registers, follow the procedure below:
•
Browse to select your file (button
);
•
Click on “Load data” button
.
A message on field
and a progress bar will inform about the status of the operation until
message “download done!” is seen. The table
is updated with the current values downloaded at
the fly as can be seen on
figure 13
.
Fig 11. SW_ADC_1_r02: “ADC - Load Registers” page
