9
EXERCISE COMPUTER
FUNCTION BUTTON
MODE
PRESS TO SELECT FUNCTION DISPLAY, AND HOLD ON PRESSING FOR
4 SECONDS TO HAVE ALL FUNCTION
VALUES TOTAL RESET.
(THERE IS NO SINGLE FUNCTION RESET AVAILABLE.)
FUNCTIONS
SCAN
AUTOMATICALLY SCANS THROUGH EACH FUNCTION
EVERY 6 SECONDS.
TIME
DISPLAYS THE ACCUMULATED TIME UP TO 99:59 DURING
EXERCISING..
SPEED
DISPLAYS THE CURRENT SPEED UP TO 999.9KM/H OR ML/H, THE VALUE.
DISTANCE
DISPLAYS THE ACCUMULATED DISTANCE UP TO 99.99 KM OR ML DURING.
CALORIES
DISPLAYS THE ACCUMULATED CALORIE CONSUPMTION UP TO 999.9 CAL DURING
EXERCISING.
(THIS DATA IS A ROUGH GUIDE FOR COMPARISON OF DIFFERENT SESSIONS
EXERCISING SESSIONS THAT CAN NOT BE USED FOR MEDICAL TREATMENT.)
N
N
O
O
T
T
E
E
1. WHEN STOP EXERCISING, THERE WILL BE A STOP SIGN SHOWN ON THE UPPER-LEFT CORNER.
2. WITH NO SIGNAL TRANSMITTED INTO THE MONITOR IN A PERIOD OF 4 MINUTES, THE LCD
DISPLAY
WILL SHUT OFF AUTOMATICALLY, AND ALL FUNCTION VALUES WILL BE STORED
3.
TURN ON THE MONITOR BY PRESSING THE BUTTON OR START EXERCISING, ALL FUNCTION
VALUES(SPEED EXCLUDED) WILL START COUNTING FROM PREVIOUS DATAS.
4. IF IMPROPER DISPLAY ON MONITOR, PLS RE-INSTALL THE BATTERIES TO HAVE A GOOD RESULT.
TROUBLE SHOOTING.
1.
Change the battery.
To change the computer battery, please slide the computer from the computer holder,
remove the battery cover on the back of the computer console, and remove the batteries. Replace with 2 x AA
batteries. Finally put the cover back on the console, and slide the computer back on the computer holder.
2.
Computer not working correctly.
If your computer is not working correctly, please check whether the lower
sensor wire is connected to the upper sensor wire, and make sure the upper sensor wire is plugged into the
computer. When you have checked the above, and the computer still not working, then please make sure the
batteries are installed correctly in the computer and that the batteries are still working.
3.
No resistance.
If there is no tension resistance on the bike, please make sure the upper tension cable is
connected to the lower tension cable. Turn the tension knob anti-clockwise to it’s lowest level, then go to the
tension strap buckle which is situated on top of the flywheel cover at the base of the front post. Loosen the
tension strap, pull it through the buckle until you can feel some resistance on the strap then lock it back around
the buckle. Now mount the cycle and turn the pedals, the tension control knob can now be used for a finer
adjustment. If you find it is now too tight go back to the tension strap buckle and loosen the strap slightly.
M
M
A
A
I
I
N
N
T
T
E
E
N
N
A
A
N
N
C
C
E
E
1. Before using the cross trainer, always make sure all bolts/nuts are fully tightened.
2. A spent battery is hazardous waste, please dispose of it correctly, and do not throw it in the trash.
3. When eventually you want to scrap the machine, you should remove the batteries from the computer, and
dispose separately as hazardous waste.
Содержание YE-5920
