VME Subrack System 7 U
Installation
20836-715/-718
www.schroff.biz
16
R1.1, November 14, 2008
3.3 Assembly of additional Backplanes
With the subrack systems 20836-715/-718 you can assemble an additional
Backplane.
Obey the following instructions:
1 Disconnect the System from the line/mains power supply.
2 Remove the front panel.
3 Mount the guide rails.
4 Remove the back panel.
Note:
Open the back panel to an angle of 135°. At this angle you can
separate the hinges and remove the back panel completely.
5 Attach the new Backplane with two M2.5 screws and isolating washers at
the top and the bottom, but do not tighten the screws.
6 To align the Backplane, insert a VME board in the outer guiderails at the left
and the right.
7 Attach the Backplane using M2.5 screws and isolating washers.
Note:
Use at least every second mounting hole at the top and the bottom.
8 Connect the Backplane to the system power.
9 Attach the rear panel.
10 Power-up the systems without the VME boards and check all VME voltages
at the backplane connectors.
Note:
For instructions see
Kapitel 3.4, "Basic Functional Check"
For more information and further assembly instruction see the Backplanes
User manual.
