nVent Hoffman X2302, Инструкция по эксплуатации

Страница: 5 / 28

nVent.com/HOFFMAN
|
5
INSTALLATION INSTRUCTIONS
1. Inspect air conditioner and verify functionality before mounting the air conditioner, “HANDLING AND TESTING THE AIR CONDITIONER”
see on page 4 .
2. Using the cutout dimensions shown in this manual, prepare the air conditioner opening, and mounting bolt hole pattern for the enclosure.
See “Mounting Cutout Dimensions” on page 6 for proper location.
3. Using the gasket kit provided, install gaskets to the enclosure using the cutout and bolt hole pattern as a guide.
4. Mount air conditioner on enclosure using mounting bolts and washers provided to secure unit to enclosure. Torque bolts to
22 . 5 in-lb
( 2 . 5 Nm). Allow unit to remain upright for a minimum of five ( 5 ) minutes before starting. Caution! Air conditioner must be in upright
position during operation.
5. To avoid cross-threading mounting inserts, start bolts by hand before tightening with a wrench or ratchet driver.
6. Refer to the top of the nameplate for electrical requirements. Connect power from a properly grounded power supply. Use of an extension
cord is not recommended. Electrical circuit should be fused with slow blow or HACR circuit breaker.
7. When the unit is equipped with an automatic temperature controller, the controller is preset at the factory for your convenience and should
not require adjustment.
Dimension drawing
10.23
260
22.32
567
13.64
346
4.49
114
5.08
129
3X .57
15
5X .54
14
1.59
40
6.50
165
7.56
192
1.04
27
6.00
152
12X 1/4-20
3.78
96
1.26
32
11.41
290
.48
12
89215771
Condensate
Drain
View of Underside of Unit
Ambient Air In
Cleanable, Reusable
Aluminum Inlet Filter
Mounting Holes
Power In
Enclosure Air In
Cool Air Out
Warm
Air Out
Terminal Block (Power
connections behind
removeable cover)