Page 5
®
Installation & Operating Instruction Manual
Setting a Configuration
Configuration
Selection Button
1. Locate the Configuration Selection Button, as shown above. It is to the
right of the green Power Indicator light located on the lower-right corner of
the Control box. This button can be used only for 20 seconds after the
power is first applied to the control box. This is to ensure that the
configuration does not get accidently changed.
2. Unplug the control box from the AC power, and wait about 10 seconds.
3. Plug the control box back in. The green Power LED will blink the current
configuration that it is in.
4. Within 20 seconds, press and hold the Configuration Button. Use a small
object such as a pen or pencil to press the button. Only gentle pressure is
required.
5. The Power LED will turn off, then blink once, indicating Configuration #1,
followed by a pause, then two blinks, indicating Configuration #2, etc.
Simply release the Configuration Button at the desired configuration
setting. The Power LED will then blink the selected configuration again, as
confirmation.
Configuration is complete and the Controller is now ready for use.
