MODELS CFC56BR • CFC56WH
Page 3
INSTALL THE FAN
1. Remove the decorative canopy bottom cover from the canopy by
turning the cover counter clockwise. (Fig. 5)
2. Remove the hanger bracket from the canopy by removing the 1 of
2 screws from the bottom of the hanger bracket and loosening the
other one a half turn from the screw head. Next, turn the canopy
counter clockwise to removing the hanger bracket from the canopy.
(Figure 5)
3. Pass the 120-volt supply wires through the center hole in the ceiling
hanger bracket as shown in Fig. 6.
4. Secure the hanger bracket to the ceiling outlet box with the screws
and washers provided with your outlet box.
5. Remove the hanger pin, locking pin and set screws from the top of
the motor assembly.
6. Route wires exiting from the top of the fan motor through the couping
cover, canopy cover and canopy, then through the ball / downrod.
(Fig. 7)
7. Align the holes at the bottom of the downrod with the holes in the
collar on top of the motor housing (Fig.7). Carefully insert the hanger
pin through the holes in the collar and downrod. Be careful not to
jam the pin against the wiring inside the downrod. Insert the locking
pin through the hole near the end of the hanger pin until it snaps
into its locked position, as noted in the circle inset of Fig. 7.
8. Tighten two set screws on top of the fan motor firmly.
(Fig. 7)
9. Place the downrod ball into the hanger bracket socket.
(Fig. 8)
FIGURE 8
REGISTRATION
SLOT
FIGURE 5
CEILING
HANGER
BRACKET
CEILING
CANOPY
CANOPY
COVER
MOUNTING SCREWS
(SUPPLIED WITH
ELECTRICAL BOX)
HOOK
CEILING
MOUNTING
PLATE
CUL LISTED
ELECTRIAL
BOX
FIGURE 6
FIGURE 7
120V WIRES
WASHERS
DOWNROD
CANOPY
SET SCREWS
LOCKING
PIN
HANGER PIN
CANOPY COVER
COUPLING
COVER
