Nussbaum UNI-LIFT 6500, Инструкция по эксплуатации и документация

Страница: 41 / 62

Opera ting instruction a nd documenta tion
UNI-LIFT 6500 - 8000
UNI LIFT 6500 - 8000 - 41 - Version 1.0
•
Continue lowering the lift (loosen set screw again) until the lift has reached its
lowest position.
• Fasten set screw and secure it by fastening the security screw.
• Turn out thread pins at both stop valves at cylinder bottom of hydraulic cylinders.
Secure them with the red security nuts.
After finishing the emergency lowering, all of the set screws must be brought into
the position they have had before. Otherwise a malfunction of the lift can occur.
•
Reinstall covering plates of both stop valves in the drive-on areas of the drive-on
rails.
• Drive off vehicle from the lift
• Shut down the lift until the defective pieces or valves have been replaced
7. Inspection and Maintenance of Nussbaum lifts
Before conducting maintenance work, preparations must be made to ensure that
during maintenance and repairwork there is no rist to the safety of people working
on or around the lift and also that there is no risk of damage to equipment being
used on or around the lift.
To guarantee best availability and operability of the lift, maintenance work contracts
are organised between our clients and their local retailers.
A service must be performed at regular intervals of 3 months by the operator in
accordance with the following service manual. If the lift is in continuous operation or
in a dirty environment, the maintenance rate must be increased.
During daily operation the lift must be closely observed to ensure that it is functioning
correctly. In the case of malfunction or leakage the technical service must be
informed.