Nussbaum COMBI LIFT 4.80 H, Руководство по эксплуатации и книга учета инспекций

Страница: 47 / 63

Operating Manual and Inspection Book
COMBI LIFT 4.80 H / HYMAX II 8000
47 Version 3.0
The loose / broken cable switch (5) is only pre-mounted at the factory! After
threading in and fastening the cable, the switch must be set according to pic-
ture below.
This is required again after each cable change or after the platform has been
moved.
1) Loose / broken cable switch 2) Cable support 3)Moving trigger element
• Fasten the crossbeam at the rail one more time.
• Fill in the hydraulic oil. (Litre ? see chapter 3.)
In case of operation the automotive-
lift, the chapter " Safety regulations” and
“Operating instruction” must be observed.
• Raise the lift until the supports can be removed. Press the button “lifting”
• Remove the supports.
• Lower the lift into the lowest position. (See chapter 5.2). Fasten the ratchet-strip.
• Raise the lift and hang the spring into ratchet strip.
pic 6: Hang the spring into the ratchet-strip
1
3
2
Maximal
40 mm
secured with
two nuts
Minimal 15
mm